1. Many outdoor enthusiasts have a misconception: that the less you wash the more you can extend the service life of the rash jacket, but not, not timely cleaning will instead shorten its service life. When the jacket is very dirty, the surface fabric breathability will be greatly reduced, wearing uncomfortable, body and hair secretion oil long-term accumulation, but also will destroy the fabric oil-proof layer and pressure tape glue, resulting in water seepage and pressure tape off.

The way and frequency of washing the rushing jacket
Dirt will corrode the fabric and reduce the breathability of the garment, so we advocate regular cleaning of the rash jacket, you can use ordinary household washing machine to clean the rash jacket, before washing first refer to the manufacturer's special instructions on care on the clothing label, if you choose dry cleaning, you should also read the wash label whether it is recommended dry cleaning. About the frequency of cleaning and ordinary jacket, the surface has dirt on the cleaning can be.

2. Machine washable clothing notes
Cleaning and maintenance points
There are a few maintenance points for machine washable jackets: pre-treat with stain remover for extra dirty parts, put in laundry bags, do not use bleach and softener, medium temperature steam ironing or medium temperature tumble drying, which helps to restore and maintain the dial water. Normal laundry detergent and neutral laundry detergent can be used to clean the rashers. Normal laundry detergent will not damage the rashers, but softener will affect the water repellent function, and some laundry detergents or laundry liquids contain softener ingredients, so be careful when using them.

Machine washable tumble dry
One of the worrying issues about machine washable rashers is whether they can be tumble dried, worrying that the washing machine's will damage the waterproof layer and pressure tape of the rashers. The tumble dry procedure for machine washing at home will not cause damage to the waterproofing of the membrane and the peeling of the pressure tape.

Ironing and drying
Dry the clothes to half dry (at least not dripping) and then iron, because the surface fabric is mostly chemical fiber, so the temperature should be adjusted to the appropriate chemical fiber fabric block, about 100 degrees, ironing can be padded with a thin layer of cloth on the clothes; drying temperature is about 80 degrees, for insurance purposes, the initial can be set to low temperature or about 50 degrees drying, according to the effect of gradually adjusting the temperature, but generally can not be higher than 80 degrees.

Storage after washing
Can not product long-term storage in a humid environment, will mold, corrosion table cloth. Should try to hang stored in a ventilated, dry place.

3. Additional instructions
Dry-cleaning punching garments
The manufacturer's care instructions will indicate whether dry cleaning is recommended, and dry cleaning will not damage the film. If you go to a professional dry cleaner, you should use clear, distilled solvents and spray water repellent restorer after dry cleaning, and the dry cleaner should avoid piercing the fabric with a needle to cause water leakage.

"Water repellent" function recovery
If the surface of the garment still cannot be condensed into water beads after washing and drying, it indicates that the durable water repellent is not working. Anyone can properly restore the water repellent function by purchasing the appropriate water repellent restorer for washing and drying (note: do not use washable water repellents, which can affect breathability). The water repellent layer needs to be restored and repaired periodically and can be restored with a water repellent.

In addition, problems caused by water repellent surface wear are often mistaken for fabric failure, e.g., damp and heavy surface fabric? This is because the water treatment depletion, so that the surface fabric to absorb moisture; and then: the inner layer of clothing with moisture? This is because the surface moisture evaporation heat dissipation, so that the clothing temperature is reduced, and the inner layer near the body part of the temperature difference, so that the inner layer of "wet wet". Meet such problems, you can "dial water" repair.